SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015FORTE5 EXREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSSMART JUNCTION BOX DIAGNOSISDTC B2520-00: TURN SIGNAL RH FRONT OPEN CIRCUITDTC INSPECTIONGDS DATA ANALYSIS
2015 Kia Forte5 EX

GDS Data Analysis

2015 Kia Forte5 EXSECTION GDS Data Analysis
  1. Connect GDS.
  2. IG "ON" and engine "OFF".
  3. Select "Diagnostic Trouble Codes (DTC)  " mode.
  4. After erase DTC, keep the vehicle condition within "the enable conditions" (Refer to "DTC DETECTING CONDITION " table).
    Fig 1: DTC Description Screen
    G00570153Courtesy of KIA MOTORS AMERICA, INC.
  5. Is the same DTC occurred again?

    YES 

    • Go to next procedure.

    NO 

    • Fault is intermittent caused by poor contact in the sensor's and/or SJB's connector or was repaired and SJB memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  • Check Right Turn Signal Lamp 
    1. IG "OFF" and connect GDS
    2. IG "ON" & ENG "OFF"
    3. Select "Actuation Test" mode.
    4. Execute "right turn signal lamp" test.
      Fig 2: Normal Result After "Turn Signal RH" Actuation Test Screen
      G00570154Courtesy of KIA MOTORS AMERICA, INC.
    5. Is right turn signal lamp working normal?

      YES 

      • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

      NO 

      • Go to next procedure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.