Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2015FORTE KOUP EX, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALCYLINDER BLOCK - 2.0LREAR OIL SEALREPAIR PROCEDURESINSTALLATION
2015 Kia Forte Koup EX, Standard Trans
Repair Procedures: Installation
2015 Kia Forte Koup EX, Standard TransSECTION Installation
- Install a new rear oil seal.
- Apply engine oil on the edge of new oil seal.
- Using SST (09231-H1100, 09214-2E000) and a hammer, tap in the oil seal (A) until the SST face is aligned with the cylinder block assembly rear face.
- Install the other parts reverse order of removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.