Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSKIA2014SOUL BASE, STANDARD TRANSREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLELECTRONIC STABILITY CONTROL (ESC) SYSTEM DIAGNOSISDTC C1616: CAN BUS OFFDTC INSPECTIONMONITOR GDS DATA

2014 Kia Soul Base, Standard Trans

Monitor GDS Data

2014 Kia Soul Base, Standard TransSECTION Monitor GDS Data

Connect GDS to Data Link Connector (DLC).
Ignition "ON".
Select correct Vehicle Model, Year, and Engine Type.
Select "Engine" and "A/T", "ESC" and "BCM (Body Control Module)" system. (1)
Select "Fault Code Searching". (2)

Fig 1: Fault Code Searching Screen
Courtesy of KIA MOTORS AMERICA, INC.
Monitor DTCs in selected systems.

Fig 2: Fault Code Searching Screen
Courtesy of KIA MOTORS AMERICA, INC.
Does selected system have any CAN related DTCs or failed to communicate via GDS?
YES
- Repair any CAN related DTCs first and then carefully re-do this troubleshooting guide steps.
- If problem still occurs, go to "WIRING INSPECTION " procedure.
NO
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.