Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2014SOUL BASE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESELECTRONIC STABILITY CONTROL (ESC) SYSTEMTROUBLESHOOTINGWHEN IGNITION KEY IS TURNED ON (ENGINE OFF), THE ABS WARNING LAMP DOES NOT LIGHT UPINSPECTION PROCEDURESCHECK THE POWER SOURCE FOR THE ABS WARNING LAMP
2014 Kia Soul Base, Standard Trans
Check the power source for the ABS warning lamp
2014 Kia Soul Base, Standard TransSECTION Check the power source for the ABS warning lamp
- Disconnect the instrument cluster connector (M01) and turn the ignition switch ON.
- Measure the voltage between terminal (M01) 39 of the cluster harness side connector and body ground.
Specification: approximately B+
Courtesy of KIA MOTORS AMERICA, INC.
Is voltage within specification?
YES
- Check the CAN circuit resistance for ABS warning lamp.
NO
- Check for blown fuse.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.