Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC U1112: LIN Communication Error: General Description
LIN technology is, a serial communication system which is used for communicating only one signal, developed to substitute CAN network, Normally used for multi signal communication. It is only single wire to make LIN communication in order to make simple network that is not important speed.
In case of ISG system, ECM/PCM receives battery information such as battery voltage, current and temperature etc.) through the LIN. With the information received through the LIN, ECM/PCM decides alternator control, idle stop and auto start by receiving battery information.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.