Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2013OPTIMA SXLREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTHEADLIGHTSAUTO HEADLAMP LEVELING SYSTEM DIAGNOSIS - EXCEPT HEV
2013 Kia Optima SXL
Auto Headlamp Leveling System Diagnosis - Except HEV
2013 Kia Optima SXLSECTION Auto Headlamp Leveling System Diagnosis - Except HEV
- DTC Index
- DTC C1212: Vehicle Speed Sensor Failure
- DTC C1255: Rear Height Sensor
- DTC C1258: Magnet Setting Error
- DTC C1367: Internal Signal Not Plausible
- DTC C1381: Sensor Internal Error
- DTC C1522: Head Lamp Switch Fault
- DTC C1604: ECU Fault
- DTC C1606: ECU Software Error
- DTC C1620: First Setup Not Completed
- DTC C2226: Output Voltage Short To Battery Or Short To Ground
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.