Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Accelerator Position Sensor (APS): Specifications: Specification
2010 Kia Rondo LX, 2.7 6SECTION Specification
WARNING: This page is about a different variant/trim than selected.
PEDAL POSITION OUTPUT VOLTAGE - ACCELERATOR POSITION SENSOR
| Pedal Position | Output Voltage (V) [Vref = 5.0V] | |
|---|---|---|
| APS1 | APS2 | |
| C.T | 0.7 ~ 0.8 | 0.29 ~ 0.46 |
| W.O.T | 3.85 ~ 4.35 | 1.93 ~ 2.18 |
SENSOR RESISTANCE - ACCELERATOR POSITION SENSOR
| Items | Sensor Resistance (kΩ) |
|---|---|
| APS1 | 0.7 ~ 1.3 [20°C (68°F)] |
| APS2 | 1.4 ~ 2.6 [20°C (68°F)] |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.