SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 3) - 2.7LDTC P0134: HO2S CIRCUIT NO ACTIVITY DETECTED (BANK 1 SENSOR 1)GENERAL INFORMATIONDTC DETECTING CONDITION
2010 Kia Rondo LX, 2.7 6

General Information: DTC Detecting Condition

2010 Kia Rondo LX, 2.7 6SECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • Monitor signal voltage
  • Poor connection
  • Open in harness
  • HO2S (B1/S1)
  • PCM
Enable Condition
  • Battery voltage ≥ 10V
  • Engine running ≥ 60 sec.
  • Engine warm-up state
  • No disable faults
  
Threshold value Case 1
  • 1.2V ≤ Voltage of HO2S ≤ 3.9V (at pumping current ON)
Case 2
  • 0.415V ≤ Voltage of HO2S ≤ 0.515V (at pumping current OFF)
  
Diagnosis time
  • Continuous (more than 76.5 sec. failure for every 90 sec. test)
MIL ON condition
  • 2 driving cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.