SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 3) - 2.7LDTC P0133: HO2S CIRCUIT SLOW RESPONSE (BANK 1 SENSOR 1)GENERAL INFORMATIONDTC DETECTING CONDITION
2010 Kia Rondo LX, 2.7 6

General Information: DTC Detecting Condition

2010 Kia Rondo LX, 2.7 6SECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • Monitor HO2S's response rate
  • Poor Connection
  • Faulty HO2S
  • PCM
Enable Conditions
  • Engine warm-up sufficiently
  • Engine run time > 60sec
  • Drive at a steady speed between 45-55 mph (72-88 km/h)
  • Engine Coolant > 70°C(158 °F)
  • No disabling faults
  
Threshold value
  • The calculated response rate is too slow (out of threshold in PCM)
Diagnosis Time
  • Continuous
MIL On Condition
  • 2 Driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.