SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 3) - 2.7LDTC P0110: INTAKE AIR TEMPERATURE SENSOR 1 CIRCUITGENERAL INFORMATIONDTC DETECTING CONDITION
2010 Kia Rondo LX, 2.7 6

General Information: DTC Detecting Condition

2010 Kia Rondo LX, 2.7 6SECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

item detecting condition Possible Cause  
DTC Strategy Case 1
  • Start Test: Monitors the difference between max and min IAT in order to detect movement in IAT.
  • Faulty IATS
Case 2
  • Drive test: Performs the max and min delta check while driving under load for a length of time followed by an idle.
  
Enable Conditions
  • Engine soaked time > 360min
  • Engine Running State
  • No fault present
  • IAT stored previous trip
  • No IAT Tests pending
Threshold value
  • Max IAT - Min IAT ≤ 3°C (5.4 °F)
Diagnosis Time
  • Continuous (10 min.)
MIL On Condition
  • 2 driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.