SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (1 OF 3) - 2.7LDTC P0108: MANIFOLD ABSOLUTE PRESSURE/BAROMETRIC PRESSURE CIRCUIT HIGH INPUTGENERAL INFORMATIONDTC DETECTING CONDITION
2010 Kia Rondo LX, 2.7 6

General Information: DTC Detecting Condition

2010 Kia Rondo LX, 2.7 6SECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • This code detects a continuous short to high in either the signal circuit or the MAP sensor
  • Connecting condition
  • Short to battery in Signal Circuit
  • Open in Ground Circuit
  • Faulty MAPS
  • Faulty PCM
Enable Conditions Case 1
  • No TPS Active Fault Present
  • Engine Running Time >10sec.
  • Engine Speed ≤ 2500rpm
  • Throttle Position ≤ 30%
Case 2
  • No TPS Active Fault Present
  • Engine Running Time >10sec.
  • Engine Speed >2500rpm
  • Throttle Position ≤ 40%
  
Threshold Value
  • MAP Signal >4.5V
Diagnosis Time
  • Continuous (More than 2.5 seconds failure for every 5 seconds test)
MIL On Condition
  • 2 Driving Cycle
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.