General Information: DTC Detecting Condition

2010 Kia Rondo LX, 2.7 6SECTION DTC Detecting Condition
DTC DETECTING CONDITION CHART

Item Detecting Condition Possible Cause
DTC Strategy
  • The MAP reading is compared to expected MAP high and low limits based on engine speed & Throttle Position
  • Faulty TPS
  • Faulty MAPS
Enable Conditions
  • Engine Coolant Temperature β‰₯ 60Β°C (Fully Warmed up state)
  • 600rpm < Engine Speed < 3000rpm
Β 
Threshold value Case 1
  • Power Test

  • Altitude compensated MAP < Calculated min. MAP data
  • Altitude compensated MAP > Calculated max. MAP data
Case 2
  • Deceleration Test

  • Altitude compensated MAP < Calculated MAP data
Β 
Diagnosis Time
  • Continuous (For 2min. in mild tip in - out Driving)
MIL On Condition
  • 2 Driving Cycles
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.