Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEM/ELECTRONIC STABILITY CONTROL (ABS/ESC) DIAGNOSISDTC C1207: WHEEL SPEED SENSOR REAR-LH RANGE-PERFORMANCE-INTERMITTENTSCANTOOL DIAGNOSTICSMONITOR SCANTOOL DATA
2010 Kia Rondo LX, 2.7 6
Monitor Scantool Data
2010 Kia Rondo LX, 2.7 6SECTION Monitor Scantool Data
- Engine "ON".
- Connect scantool to Data Link Connector (DLC).
- Start and drive vehicle in gear and maintain vehicle speed at or above 40 km/h. (24.9 mph).
- Monitor the "WHEEL SPEED (RL)" parameter on the Scantool.
- Specification : Compare with other parameters related to wheel speed sensor.
If it is the same as other parameters, it is in normal condition.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.