Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCONTROL UNITS
2010 Kia Rondo LX, 2.7 6
Control Units
2010 Kia Rondo LX, 2.7 6SECTION Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS Control Module | Left rear of engine compartment, below brake master cylinder. See Figure. |
| A/C Control Module | Behind center of dash. See Figure. |
| ATM Key Lock Control Module | Behind center of dash. See Figure. |
| BCM | Under left side of dash. See Figure. |
| DRL Control Module | On instrument panel junction box. See Figure. |
| ESC Control Module | Left rear of engine compartment, below brake master cylinder. See Figure. |
| Immobilizer Control Module | Base of steering column. See Figure. |
| PCM | Left rear of engine compartment. See Figure. |
| Rear Parking Assist Control Module | At left "C" pillar. See Figure. |
| SRS Control Module | Under center of dash. See Figure. |
| Sunroof Control Module | On right "C" pillar. See Figure. |
| Tire Pressure Monitoring Module | Behind center of dash. See Figure. |
| Weight Classification Module | Under front passenger seat. See Figure. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.