SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010RONDO LX, 2.7 6REPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM DIAGNOSIS (3 OF 3) - 2.7LDTC P0564: CRUISE CONTROL MULTI-FUNCTION INPUT A CIRCUITINSPECTION/REPAIRCOMPONENT INSPECTION
2010 Kia Rondo LX, 2.7 6

Component Inspection

2010 Kia Rondo LX, 2.7 6SECTION Component Inspection
  1. Check auto cruise switch
    1. IG "OFF" and disconnect auto cruise switch connector.
    2. Measure resistance between terminals 6 and 5 of auto cruise switch connector with each switch depressed. (Component side)
    3. Measure resistance between terminals 6 and 7 of auto cruise switch connector with each switch depressed. (Component side)
      1. Specification:
        RESISTANCE SPECIFICATION CHART

        Item Resistance(Ω)
        ON/OFF switch 3.9 kΩ ± 5% between terminals 6 and 7
        SET switch 220 Ω ± 5% between terminals 6 and 5
        RESUME switch 910 Ω ± 5% between terminals 6 and 5
        CANCEL switch 0 Ω ± 5% between terminals 6 and 5
        Fig 1: Measuring Resistance Between Terminals 6 & 5 Of Auto Cruise Switch Connector With Each Switch Depressed
        G06489360Courtesy of KIA MOTORS AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.