Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010MAGENTIS (CANADA) V6-2.7LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW GLASSFRONT DOOR WINDOW GLASSSERVICE AND REPAIR
2010 Kia Magentis (CANADA) V6-2.7L
Front Door Window Glass: Service and Repair
2010 Kia Magentis (CANADA) V6-2.7LSECTION Service and Repair
REPLACEMENT
GLASS REPLACEMENT
1. Remove the front door trim.
2. Remove the door trim seal.
3. Carefully move the glass (A) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot
4. Installation is the reverse of removal.
NOTE:
- Roll the glass up down to see if it move freely without binding.
- Adjust the position of the glass as necessary.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.