Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010FORTE L4-2.4LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSWINDOW REGULATORREAR DOOR WINDOW REGULATORSERVICE AND REPAIR
2010 Kia Forte L4-2.4L
Rear Door Window Regulator: Service and Repair
2010 Kia Forte L4-2.4LSECTION Service and Repair
Module Assembly Replacement
1. Remove the following parts.
A. Door trim.
B. Window glass.
C. Outside handle.
2. Disconnect the rod (A).
3. After loosening the door module mounting bolts, remove the door module (A).
4. Disconnect the connector.
5. Detach the clips, then remove the wiring harness.
6. Installation is the reverse of removal.
NOTE:
- The area of whole parts should be applied with sufficient grease.
- Make sure the connector is plugged in properly and each rod is connected securely.
- Make sure the door lock and open properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.