Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010FORTE EX, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM DIAGNOSIS (SULEV) (2 OF 2)DTC P0564: CRUISE CONTROL MULTI-FUNCTION INPUT A CIRCUITINSPECTION/REPAIRCOMPONENT INSPECTION
2010 Kia Forte EX, Standard
Component Inspection
2010 Kia Forte EX, StandardSECTION Component Inspection
- Check auto cruise switch
- IG key OFF.
- Disconnect 'CRUISE REMOCON SWITCH' connector.
- Measure resistance between 'Signal (Cruise SW) ' terminal and 'CRUISE MAIN' terminal of 'CRUISE REMOCON SWITCH' harness connector with each switch depressed. (Component side) )
- Measure resistance between 'Signal (Cruise SW) ' terminal and 'Ground (Cruise SW) ' terminals of 'CRUISE REMOCON SWITCH' harness connector. (Component side)
Specification :
RESISTANCE SPECIFICATIONItem Resistance (Ω) Item Resistance (Ω) CRUISE MAIN switch 3.9 kΩ ± 5% COAST SET switch 220 Ω ± 5% CANCEL switch 0 Ω ± 5% RESUME/ACCEL switch 910 Ω ± 5% - Is the measured value within specification?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Replace 'CRUISE REMOCON SWITCH' and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NOTE: There is a memory reset function on the scantool that can erase optional parts that are automatically detected and memorized by the ECM (PCM) . Before or after testing an ECM (PCM) on a vehicle, use this function so that the ECM (PCM) can be re-used.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.