Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010BORREGO 2WD (CANADA) V8-4.6LREPAIR AND DIAGNOSISBODY AND FRAMESEATSMEMORY POSITIONING SYSTEMSMEMORY POSITIONING MODULESERVICE AND REPAIR
2010 Kia Borrego 2WD (CANADA) V8-4.6L
Memory Positioning Module: Service and Repair
2010 Kia Borrego 2WD (CANADA) V8-4.6LSECTION Service and Repair
Removal
1. Remove the negative (-) battery terminal.
2. Remove the driver seat (A) in the car.
3. Remove the IMS module (A) after loosening 4 screws in the bottom of seat.
Installation
1. Install the IMS module after reconnecting the connector.
2. Install the driver seat.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.