Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2010BORREGO 2WD (CANADA) V8-4.6LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTRELAYS AND MODULES - ACCESSORIES AND OPTIONAL EQUIPMENTPARKING ASSIST CONTROL MODULESERVICE AND REPAIRREPAIR PROCEDURES
2010 Kia Borrego 2WD (CANADA) V8-4.6L
Repair Procedures
2010 Kia Borrego 2WD (CANADA) V8-4.6LSECTION Repair Procedures
Removal
1. Remove the rear left quarter trim of the trunk
2. Loosen the mounting nuts and remove the rear parking assist system control module unit (A) from the quarter panel.
Installation
1. Reassemble the rear parking assist system control module.
2. Reassemble the rear left quarter trim.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.