Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2009 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE

DTC P0708 Transaxle Range Switch-Multi-Input: DTC Detecting Condition

DTC DETECTING CONDITION CHART

Item	Detecting Condition & Fail Safe	Possible cause
DTC Strategy	Check for multiple signals	Open or short in TRANSAXLE RANGE SWITCH Faulty TRANSAXLE RANGE SWITCH Faulty PCM
Enable Conditions	Engine speed ≥ 500 RPM OUTPUT SPEED (PG-B) ≥ 0 RPM
Threshold Value	Multiple signal
Diagnostic Time	More than 30sec
Fail Safe	Recognition as previous signal When signal is input "D" and "N" at the same time, PCM regards it as "N" RANGE. After PCM reset, if the if the PCM detects multiple signal or no signal, then it holds the 3rd gear position.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.