Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2008 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Immobilizer Control System
- Description
- Components Operations
- System Block Diagram
- Teaching Procedures
- Limp Home Function
- Diagnosis Of Immobilizer Faults
- DTC P1610 Non-Immobilizer-Ems Connected To An Immobilizer
- DTC P1674 Transponder Status Error
- DTC P1675 Transponder Programming Error
- DTC P1676 SMARTRA Message Error
- DTC P1690 SMARTRA No Response
- DTC P1691 Antenna Coil Error
- DTC P1692 Immobilizer Lamp Error
- DTC P1693 Transponder No Response Error / Invalid Response
- DTC P1694 Ems Message Error
- DTC P1695 Ems Memory Error
- DTC P1696 Authentication Fail
- DTC P1697 Hi-Scan Message Error
- DTC P1699 Twice Over Trial
- Immobilizer Control Unit
- Coil Antenna
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.