Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Rondo BaseFACTORY OEM SERVICE PROCEDURE
Operating Components And Functions
OPERATING COMPONENTS AND FUNCTIONS
| Sensor | Function |
|---|---|
| Input shaft speed sensor | Detect turbine speed at UD retainer |
| Output shaft speed sensor | Detect T/F drive gear speed at T/F driven gear (4A/T) |
| Crank angle sensor | Detect engine speed |
| TPS (Gasoline) | Throttle opening ratio by potentiometer |
| Air conditioner switch | A/C load by thermister |
| Inhibitor switch | Select lever position by contact switch |
| Brake switch | Brake pedal position |
| Vehicle speed sensor | Detect vehicle speed by speedometer driven gear |
| Sport mode switch | Sport mode On/Off signal |
| Sport mode up-shift switch | Sport mode up-shift signal |
| Sport mode downshift switch | Sport mode downshift signal |
| Request of torque reduction | Send the request of torque reduction to ECM |
| ABS-ECM, Engine ECM | In case of CAN communication |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.