2007 Kia Rondo BaseFACTORY OEM SERVICE PROCEDURE

Controller Area Network (Can)

Previously, for different computers in the vehicle to share the same information, each signal required a different pin and wiring. However, with the introduction of a CAN system, only two lines are required to achieve the same function. The information is in digital format. This method does not use an integrated ECM.

Fig 1: Identifying CAN System
G05186312Courtesy of KIA MOTORS AMERICA, INC.

Input signals to TCM (PCM) through' CAN communication'Β 

  • Engine RPM, TPS signal
  • A/C ON signal, Engine coolant temperature
  • Quantity of intake airflow, Vehicle speed
  • Shift holding signal (FTCS ON)

Output signals from TCM (PCM) through' CAN communication'Β 

  • Request signal for torque reduction
  • ATF temperature, TCM (PCM) type, TCM (PCM) error or not
  • Damper clutch ON, OFF / Gear position
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.