Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Abs Connector Input/Output
ABS CONNECTOR INPUT/OUTPUT REFERENCE
| Connector Terminal | Specification | |
|---|---|---|
| No | Description | |
| 4 | IGNITION1( + ) | Over voltage range: 16.5 ± 0.5 V < V Operating voltage range: 9.5 ± 0.5 V < V < 16.5 ± 0.5 V Low voltage range: 7.0 ± 0.5 V < V < 9.5 ± 0.5 V Max. current: I < 300 mA |
| 25 | POS. BATTERY.(SOLENOID) | Max leakage current: I < 0.8 mA Operating voltage range: 9.5 ± 0.5 V < V < 16.5 ± 0.5 V Max current: I < 30 A |
| g | POS, BATTERY.(MOTOR) | Operating voltage range: 9.5 ± 0.5 V < V < 16.5 ± 0.5 V Rush current: I < 100 A Max current: I < 30 A Max leakage current: I < 0.2 mA |
| 8 | GROUND | Rated current: I < 300 mA Max. current: I < 30 A |
| 24 | PUMP MOTOR GROUND | Rush current: I < 100 A Max current: I < 30 A |
| 18 | BRAKE LIGHT SWITCH | Input voltage low: 0 V ≤ V ≤ 3.0 V Input voltage High: 7.0 V ≤ V ≤ 16.0 V |
| 16 | ABS/EBD W/LAMP DRIVE | Max. current: I < 200 mA Max. output low voltage: V < 1.2 V |
| 1 | SENSOR FRONT LEFT POWER |
|
| 19 | SENSOR FRONT RIGHT POWER | |
| 5 | SENSOR REAR LEFT POWER | |
| 23 | SENSOR REAR RIGHT POWER | |
| 2 | SENSOR FRONT LEFT SIGNAL |
|
| 20 | SENSOR FRONT RIGHT SIGNAL | |
| 6 | SENSOR REAR LEFT SIGNAL | |
| 22 | SENSOR REAR RIGHT SIGNAL | |
| 7 | DIAGNOSIS INPUT/OUTPUT | Input voltage: VI_L < 0.3 IGN[V] VI_H > 0.7 IGN[V] Output voltage: VO_L < 0.2 IGN[V] VO_H > 0.8 IGN[V] |
| 3 | SENSOR FRONT RIGHT OUTPUT | Maximum Current: I < 2 mA External pull up resister: 10KΩ < R Output duty: 50 ± 20 % |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
