Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Kia Rio Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Abs (Anti-Lock Brake System)
- Components
- Description
- Abs Control
- Abs Circuit Diagram
- Abs Connector Input/Output
- Hi-Scan (Pro) Check
- Problem Symptoms
- Notes
- ABS Does Not Operate
- ABS Does Not Operate Intermittently.
- Communication With Hi-Scan (pro) Is Not Possible. (Communication With Any System Is Not Possible)
- Communication With Hi-Scan (pro) Is Not Possible. (Communication With ABS Only Is Not Possible)
- When Ignition Key Is Turned ON (Engine OFF), The ABS Warning Lamp Does Not Light Up.
- Even After The Engine Is Started, The ABS Warning Lamp Remains ON.
- Bleeding Brake System
- Diagnostic Trouble Codes
- Notes
- DTC C1101 Battery Voltage High
- DTC C1102 Battery Voltage Low
- DTC C1200 Wheel Speed Sensor Front-LH Open/Short; DTC C1203 Wheel Speed Sensor Front-RH Open/Short; DTC C1206 Wheel Speed Sensor Rear-LH Open/Short; DTC C1209 Wheel Speed Sensor Rear-RH Open/Short
- DTC C1201 Wheel Speed Sensor Front-LH Range / Performance / Intermittent; DTC C1204 Wheel Speed Sensor Front-RH Range / Performance / Intermittent; DTC C1207 Wheel Speed Sensor Rear-LH Range / Performance / Intermittent; DTC C1210 Wheel Speed Sensor Rear-RH Range / Performance / Intermittent
- DTC C1202 Wheel Speed Sensor Front-LH Invalid/No Signal; DTC C1205 Wheel Speed Sensor Front-RH Invalid/No Signal; DTC C1208 Wheel Speed Sensor Rear-LH Invalid/No Signal; DTC C1211 Wheel Speed Sensor Rear-RH Invalid/No Signal
- DTC C1604 Ecu Hardware Error
- DTC C2112 Valve Relay Error
- DTC C2380 Abs Valve Error
- DTC C2402 Motor - Electrical
- Anti-Lock Braking System Control Module
- Front Wheel Speed Sensor
- Rear Wheel Speed Sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
