Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2006MAGENTIS (CANADA) L4-2.4L VIN 3REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINESYSTEM SPECIFICATIONSSEQUENCESROD BEARING CAP
2006 Kia Magentis (CANADA) L4-2.4L VIN 3
Rod Bearing Cap
2006 Kia Magentis (CANADA) L4-2.4L VIN 3SECTION Rod Bearing Cap
Rod Bearing Cap
Install piston and connecting rod assemblies.
NOTE: Before installing the pistons, apply a coat of engine oil to the ring grooves and cylinder bores.
Remove the connecting rod caps, and slip short sections of rubber hose over the threaded ends of the connecting rod bolts.
Install the ring compressor, check that the bearing is securely in place, then position the piston in the cylinder, and tap it in using the wooden handle of a hammer.
Stop after the ring compressor pops free, and check the connecting rod-to-check journal alignment before pushing the piston into place.
Apply engine oil to the bolt threads. Install the rod caps with bearings, and torque the bolts.
Tightening torque 19.6 Nm (2.0 kgf.m, 14.46 ft. lbs.) + 90°
NOTE: Maintain downward force on the ring compressor to prevent the rings from expanding before entering the cylinder bore.
Install piston and connecting rod assemblies.
NOTE: Before installing the pistons, apply a coat of engine oil to the ring grooves and cylinder bores.
Remove the connecting rod caps, and slip short sections of rubber hose over the threaded ends of the connecting rod bolts.
Install the ring compressor, check that the bearing is securely in place, then position the piston in the cylinder, and tap it in using the wooden handle of a hammer.
Stop after the ring compressor pops free, and check the connecting rod-to-check journal alignment before pushing the piston into place.
Apply engine oil to the bolt threads. Install the rod caps with bearings, and torque the bolts.
Tightening torque 19.6 Nm (2.0 kgf.m, 14.46 ft. lbs.) + 90°
NOTE: Maintain downward force on the ring compressor to prevent the rings from expanding before entering the cylinder bore.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.