Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2006MAGENTIS (CANADA) L4-2.4L VIN 3REPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYPISTON, ENGINE
2006 Kia Magentis (CANADA) L4-2.4L VIN 3
Piston, Engine
2006 Kia Magentis (CANADA) L4-2.4L VIN 3SECTION Piston, Engine
Piston
Piston outer diameter 87.975 - 88.005 mm (3.4636 - 3.4648 inch)
Piston to cylinder clearance 0.015 - 0.035 mm (0.0028 - 0.0014 inch)
Ring groove
No. 1 ring groove
Specifications 1.22 - 1.24 mm (0.0006 - 0.0488 inch)
Limit 1.26 mm (0.0496 inch)
No. 2 ring groove width
Specifications 1.22 - 1.24 mm (0.0480 - 0.0488 inch)
Limit 1.26 mm (0.0496 inch)
Oil ring groove
Specifications 2.01 - 2.03 mm (0.0791 - 0.0799 inch)
Limit 2.05 mm (0.0807 inch)
Piston outer diameter 87.975 - 88.005 mm (3.4636 - 3.4648 inch)
Piston to cylinder clearance 0.015 - 0.035 mm (0.0028 - 0.0014 inch)
Ring groove
No. 1 ring groove
Specifications 1.22 - 1.24 mm (0.0006 - 0.0488 inch)
Limit 1.26 mm (0.0496 inch)
No. 2 ring groove width
Specifications 1.22 - 1.24 mm (0.0480 - 0.0488 inch)
Limit 1.26 mm (0.0496 inch)
Oil ring groove
Specifications 2.01 - 2.03 mm (0.0791 - 0.0799 inch)
Limit 2.05 mm (0.0807 inch)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.