Sensor Initiating Procedure

2006 Kia Magentis (CANADA) L4-2.4L VIN 3SECTION Sensor Initiating Procedure
Sensor Initiating Procedure








1. Read the four sensors ids starting with sensor 1 (1 normally front left, 2 front right, 3 rear left, 4 rear right).





2. Connect 'TPMS exciter' to the diagnostic connector.








3. Register the four sensor's ids to the receiver.
4. Disconnect diagnostic link.
5. Cycle Ignition, wait 4 minutes and check that Normal Receiver State is now indicated.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.