Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Kia Spectra Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Specifications Index
SPECTRA SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Nut/Hub Nut | 154-205 ft. lbs. (210-279 N.m) | |
| Battery | N/A | |
| Brakes | ||
| Bleeding Sequence | AIR BLEEDING (CBS) or AIR BLEEDING | |
| Disc Brakes | SPECIFICATIONS | |
| Drum Brakes | SPECIFICATIONS | |
| Torque | Torque specifications are found in text in DISC & DRUM article. | |
| Charging | ||
| Generator | SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT ADJUSTMENT | |
| Belt Routing | DRIVE BELT ROUTING | |
| Engine Cooling | ||
| General Service Specifications | COOLING SYSTEM SPECIFICATION | |
| Radiator Cap Pressure | 15 psi | |
| Thermostat R & I | THERMOSTAT | |
| Water Pump R & I | ENGINE COOLANT PUMP | |
| Engine Mechanical | ||
| Compression | ENGINE COMPRESSION | |
| Oil Pressure | Oil pressure should be 43-57 psi (294-392 kPa) at 3000 RPM. | |
| Overhaul | See figure under ENGINE SPECIFICATIONS . | |
| Torque | TORQUE SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flexplate Torque | 72-76 ft. lbs. (97-103 N.m) | |
| Fuel System | ||
| Fuel Filter Location | FUEL FILTER | |
| Pressure Specification | FUEL PUMP | |
| Fuel Pressure Test Procedure | FUEL PRESSURE | |
| Fuel Pressure Release Procedure | FUEL PRESSURE RELEASE | |
| Ignition | ||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | |
| Ignition Wires (Routing) | HIGH TENSION WIRE RESISTANCE | |
| Spark Plugs | SPARK PLUGS | |
| Starting | ||
| Starter | STARTER SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | |
| Torque | Torque specifications are included in the text in SPECIFICATIONS & PROCEDURES article. | |
| Wheel & Tire | ||
| Lug Nut Torque | 65-87 ft. lbs. (88-118 N.m) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
