Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA2001SEPHIA LS L4-1.8LREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECYLINDER BLOCK ASSEMBLYCONNECTING ROD BEARING
2001 Kia Sephia LS L4-1.8L
Connecting Rod Bearing
2001 Kia Sephia LS L4-1.8LSECTION Connecting Rod Bearing
SERVICE SPECIFICATIONS
Connecting Rod Wrist Pin:
Inside Diameter 0.9055 - 0.9063 inch (23.0 - 23.021 mm)
Oil Clearance 0.0004 - 0.0010 inch (0.010 - 0.027 mm)
Connecting Rod Bearing Clearance:
Standard 0.0008 - 0.0019 inch (0.0020 - 0.05 mm)
Maximum 0.004 inch (0.10 mm)
Connecting Rod Side Clearance:
Do Not Measure Between Connecting Rod Cap And Crankshaft:
Standard 0.0044 - 0.0103 inch (0.110 - 0.262 mm)
Maximum 0.012 inch (0.30 mm)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.