Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSKIA1996SEPHIA RS, 1.6 3REPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESKIASERVICE PRECAUTIONS
1996 Kia Sephia RS, 1.6 3
Service Precautions
1996 Kia Sephia RS, 1.6 3SECTION Service Precautions
Observe the following precautions when servicing SRS:
- Disable SRS before servicing any SRS or steering column component. Failure to do this could result in accidental air bag deployment and possible personal injury. See .
- After turning ignition switch to LOCK position and disconnecting negative battery cable, wait at least 30 minutes before working on SRS. SRS is equipped with a back-up power source that may allow air bag to deploy within 30 minutes after disconnecting negative battery cable.
- In a minor collision in which air bags did not deploy, inspect front air bag sensors and steering wheel pad.
- NEVER use air bag parts from another vehicle. Replace air bag parts with new parts.
- Never disassemble or repair system components. Replace cracked, dented or otherwise damaged system component.
- DO NOT expose front air bag sensors, center air bag sensor assembly, steering wheel pad, passenger-side air bag or seat belt pretensioner to heat or flame.
- After servicing SRS, check air bag warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECKΒ .
- Always wear safety glasses when servicing or handling an air bag.
- When placing a live air bag on a bench or other surface, always face air bag and trim cover upward, away from surface. This will reduce motion of module if it is accidentally deployed.
- After deployment, air bag surface may contain deposits of sodium hydroxide, which irritates skin. Always wear safety glasses, rubber gloves and long-sleeved shirt during clean-up. After clean-up, wash hands using mild soap and water.
- When carrying a live air bag module, trim cover must be pointed away from your body to minimize injury in case of accidental deployment.
- If SRS is not fully functional for any reason, vehicle should not be driven until system is repaired and again becomes operational. DO NOT remove bulbs, modules, sensors or other components or in any way disable system from operating normally. If SRS is not functional, park vehicle until it is repaired and functions properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.