Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSKIA1996SEPHIA RS, 1.6 3REPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESAUDISERVICE PRECAUTIONS
1996 Kia Sephia RS, 1.6 3
Service Precautions
1996 Kia Sephia RS, 1.6 3SECTION Service Precautions
Observe these precautions when working with air bag systems:
- Before disconnecting battery cable(s) and disabling air bag system, obtain radio security code from vehicle owner.
- Before installing computer memory saver on vehicles with electronic radio lock, disconnect air bag voltage supply connector. See DISABLING ACTIVATING AIR BAG SYSTEM . Failure to do so may cause air bag activation.
- Disable air bag system before servicing any air bag system or steering column component. See DISABLING ACTIVATING AIR BAG SYSTEM .
- Because of critical operating requirements of system, DO NOT attempt to service any air bag system component.
- DO NOT leave air bag parts unattended. Install air bag parts in vehicle immediately after they are obtained.
- DO NOT use air bag components that have been dropped from heights of approximately 20" or higher.
- DO NOT allow chemical cleaners, oil or grease to contact vinyl covering on air bag unit.
- DO NOT place stickers or covers on steering wheel.
- Disable SRS before performing electric welding on vehicle.
- DO NOT expose air bag unit to temperatures greater than 212°F (100°C).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.