Torque Specifications - Steering Column

2024 Jeep Wagoneer L Series II, RWDSECTION Torque Specifications - Steering Column
GC0204361Courtesy of CHRYSLER GROUP, LLC
CALLOUT DESCRIPTION SPECIFICATION COMMENT
1 Intermediate Shaft Lower Pinch Bolt 50 N. m (37 Ft. Lbs.) Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
2 Intermediate Shaft Upper Pinch Bolt 28 N. m (21 Ft. Lbs.) Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
3 Intermediate Shaft Bearing Nuts 8 N. m (71 In. Lbs.) -
4 Steering Column Nuts 28 N. m (21 Ft. Lbs.) -
5 Steering Wheel Nut 45 N. m (33 Ft. Lbs.) Do not reuse these fasteners. If removed, a new fastener must be installed and tightened to specifications.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.