Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024WAGONEER L SERIES II, RWDREPAIR AND DIAGNOSISBODY & FRAMETOWING SYSTEMSINTEGRATED TRAILER CONTROL MODULE (ITCM) - DTCS B235C-64 TO C10CB-8F
2024 Jeep Wagoneer L Series II, RWD
Integrated Trailer Control Module (ITCM) - DTCS B235C-64 To C10CB-8F
2024 Jeep Wagoneer L Series II, RWDSECTION Integrated Trailer Control Module (ITCM) - DTCS B235C-64 To C10CB-8F
- DTC Troubleshooting
- B235C-64 Trailer Connection - Signal Plausibility Failure
- C10C6-11 Electronic Trailer Brake Manual Lever - Circuit Short To Ground
- C10C6-12 Electronic Trailer Brake Manual Lever - Circuit Short To Battery
- C10C6-92 Electronic Trailer Brake Manual Lever - Performance Or Incorrect Operation
- C10C7-00 Electronic Trailer Brake Control Output
- C10C7-11 Electronic Trailer Brake Control Output - Circuit Short To Ground
- C10C7-12 Electronic Trailer Brake Control Output - Circuit Short To Battery
- C10C7-19 Electronic Trailer Brake Control Output - OVERCURRENT
- C10C9-00 Electronic Trailer Brake Manual Lever Fail-Safe Circuit
- C10CA-11 ITBM Adjustment Switch - Circuit Short To Ground
- C10CA-12 ITBM Adjustment Switch - Circuit Short To Battery
- C10CB-8F Vehicle Speed Output - Erratic
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.