Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024WAGONEER L SERIES II, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTENTERTAINMENT SYSTEMS(VIDEO ROUTING MODULE (VRM) - ELECTRICAL DIAGNOSTICS)
2024 Jeep Wagoneer L Series II, RWD
(Video Routing Module (VRM) - Electrical Diagnostics)
2024 Jeep Wagoneer L Series II, RWDSECTION (Video Routing Module (VRM) - Electrical Diagnostics)
- Diagnostic Code Index
- DTC Troubleshooting
- B1570-00 USB Communication
- B15AA-00 Lost Low Voltage Differential Signal (LVDS) Connection With Display 1
- B15AB-00 Lost Low Voltage Differential Signal (LVDS) Connection With Display 2
- B15AD-00 Lost Low Voltage Differential Signal (LVDS) Connection With Media Port 1
- B15AE-00 Lost Low Voltage Differential Signal (LVDS) Connection With Media Port 2
- B2199-16 Battery Voltage - Circuit Voltage Below Threshold
- B2199-17 Battery Voltage - Circuit Voltage Above Threshold
- B210A-00 System Voltage Low
- B210B-00 System Voltage High
- B2204-00 Ecu Configuration Mismatch
- B22A9-00 Ecu Internal Performance
- U0080-00 ETHERNET Bus 1
- U0140-00 Lost Communication With Body Control Module
- U0184-00 Lost Communication With Radio
- U1065-00 High Speed FD-Can8 Communication Bus
- U1066-00 High Speed FD-Can8 Communication Bus Performance
- U11F5-00 Lost Communication With External Disc Module
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.