Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024WAGONEER L SERIES II, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESDRIVETRAIN CONTROL MODULE (DTCM) - DTCS C1415-92 TO C14AD-12
2024 Jeep Wagoneer L Series II, RWD
Drivetrain Control Module (DTCM) - DTCS C1415-92 To C14AD-12
2024 Jeep Wagoneer L Series II, RWDSECTION Drivetrain Control Module (DTCM) - DTCS C1415-92 To C14AD-12
- DTC Troubleshooting
- C1415-92 Transfer Case Motor Current-Performance Or Incorrect Operation
- C1423-64 Transfer Case Internal Performance-Signal Plausibility Failure
- C1444-98 T-Case Motor Overuse-Component Or System Over Temperature
- C1463-12 Front Axle Disconnect Control-Circuit Short To Battery
- C1463-14 Front Axle Disconnect Control-Circuit Short To Ground Or Open
- C1476-46 Transfer Case Clutch Position Out Of Range-Calibration - Parameter Memory Failure
- C1477-4B Transfer Case Clutch-Over Temperature
- C147B-11 Front Axle Disconnect Sensor-Circuit Short To Ground
- C147B-12 Front Axle Disconnect Sensor-Circuit Short To Battery
- C147B-64 Front Axle Disconnect Sensor-Signal Plausibility Failure
- C147E-11 Front Axle Disconnect Power Supply-Circuit Short To Ground
- C147E-12 Front Axle Disconnect Power Supply-Circuit Short To Battery
- C149E-64 Transfer Case Motor Position Sensor-Signal Plausibility Failure
- C149E-8F Transfer Case Motor Position Sensor-Erratic
- C14AA-11 Transfer Case Motor Position Sensor Supply - Circuit Short To Ground
- C14AA-12 Transfer Case Motor Position Sensor Supply-Circuit Short To Battery
- C14AA-1C Transfer Case Motor Position Sensor Supply-Circuit Voltage Out Of Range
- C14AB-12 Transfer Case Motor Position Sensor Return-Circuit Short To Battery
- C14AD-11 Transfer Case Range Position Sensor Supply-Circuit Short To Ground
- C14AD-12 Transfer Case Range Position Sensor Supply-Circuit Short To Battery
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.