Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024WAGONEER L SERIES II, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEDRIVER ASSISTANCE SYSTEMCAMERASREMOVAL AND INSTALLATIONNIGHT VISION CAMERA
2024 Jeep Wagoneer L Series II, RWD
Night Vision Camera
2024 Jeep Wagoneer L Series II, RWDSECTION Night Vision Camera
REMOVAL
- Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION
.
1 - Fasteners 2 - Wire Harness Connector 3 - Night Vision Camera - Disconnect the wire harness connector from the night vision camera.
- Remove the fasteners securing the night vision camera to the front fascia.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Tighten the fasteners securely.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.