Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Long Range Camera Front
This routine is needed when a Long Range Camera Front (LRCF) is replaced or a Diagnostic Trouble Code (DTC) is set indicating a loss of calibration.
Confirm that the mirror mount is not loose prior to performing this routine. A loose mirror mount can keep the LRCF from calibrating.
- Using the scan tool, navigate to the CADM "Misc. Functions" menu.
- Select and run the routine "Forward Facing Camera Dynamic Service Alignment/Calibration".NOTE:
This routine pertains only to the LRCF on the front windshield.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.