Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024WAGONEER L CARBIDE, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCEDRIVER ASSISTANCE SYSTEMMODULESREMOVAL AND INSTALLATIONNIGHT VISION PROCESSING MODULE
2024 Jeep Wagoneer L Carbide, RWD
Night Vision Processing Module
2024 Jeep Wagoneer L Carbide, RWDSECTION Night Vision Processing Module
REMOVAL
- Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION
.
1 - Wire Harness Connectors 2 - Bracket - Disconnect the wire harness connectors from the Night Vision Processing Module (NVPM).
- Disengage the tabs securing the NVPM to the NVPM bracket.
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.