SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE L LIMITED, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 22 (5.7L - DTCS P0155 TO P0175)DTC TROUBLESHOOTINGP0159-O2 SENSOR 2/2 SLOW RESPONSEDIAGNOSTIC TEST
2024 Jeep Grand Cherokee L Limited, RWD

Diagnostic Test

2024 Jeep Grand Cherokee L Limited, RWDSECTION Diagnostic Test
WARNING: This page is about a different variant/trim than selected.
  1. READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN 
    1. With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
    2. For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
    3. With the scan tool, erase all DTCs.
    4. Turn the ignition off for a minimum of 10.0 seconds.
    5. Turn the ignition on.
    6. Using the When Monitored Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
    7. With the scan tool, read DTCs.

      Did the DTC return?

      Yes 

      • Go To  2

      No 

  2. CHECKING THE EXHAUST SYSTEM FOR LEAKS 
    1. Perform the CHECKING THE EXHAUST SYSTEM FOR LEAKS test procedure. Refer to CHECKING THE EXHAUST SYSTEM FOR LEAKS .

      Were any exhaust leaks found?

      Yes 

      • Repair or replace the leaking exhaust parts as necessary.
      • Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .

      No 

      • Go To  3
  3. CHECK THE O2 SENSOR 2/2 (K243) SIGNAL CIRCUIT FOR PROPER VOLTAGE AT THE O2 SENSOR HARNESS CONNECTOR 
    1. Turn the ignition off.
    2. Disconnect the harness connector at the component of the circuit being tested. Note:  The ECU harness connector should still be connected during this test step.
    3. Turn the ignition on.
    4. Set the DVOM to measure DC voltage.
    5. Connect the negative lead of the DVOM to a known good ground.
    6. With the positive lead of the DVOM, measure the voltage of the circuit being tested at the component harness connector.
    7. If it is necessary to probe a terminal at a PCM harness connector, connect the (special tool #10436, Adapter, GPEC Diagnostic)
      NOTE:

      Normal operating voltage should be between 4.1 and 5.0 volts.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.