Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE L LIMITED, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 66 (2.0L - DTCS P0117 TO P0133)DTC TROUBLESHOOTINGP0117-ENGINE COOLANT TEMPERATURE SENSOR CIRCUIT LOWWHEN MONITORED
2024 Jeep Grand Cherokee L Limited, RWD
When Monitored
2024 Jeep Grand Cherokee L Limited, RWDSECTION When Monitored
WARNING: This page is about a different car, the 2024 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
This diagnostic runs continuously when the following conditions are met:
- With the ignition on.
- Battery voltage greater than 10.4 volts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.