Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE L LIMITED, RWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 40 (HYBRID CONTROL PROCESSOR MODULE (HCP) - DTCS P0C17-00 TO P0C74-00)DTC TROUBLESHOOTINGP0C17-00-DRIVE MOTOR A POSITION SENSOR 1 NOT LEARNEDSET CONDITION
2024 Jeep Grand Cherokee L Limited, RWD
Set Condition
2024 Jeep Grand Cherokee L Limited, RWDSECTION Set Condition
WARNING: This page is about a different car, the 2024 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Offset not learned due to any one or more of the following reasons:
- Electric Drive Motor speed is greater than 50 rpm.
- High Voltage (HV) battery voltage is less than 192 volts.
- Difference of the Electric Drive Motor phase to phase current is less than 15 amps.
- Learned value is greater than 25 degrees.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.