Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE L LIMITED, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESDRIVETRAIN CONTROL MODULE (DTCM) - DTCS C1472-92 TO U0101-87DTC TROUBLESHOOTINGC14AD-15-TRANSFER CASE RANGE POSITION SENSOR SUPPLY-CIRCUIT SHORT TO BATTERY OR OPENDEFAULT ACTION
2024 Jeep Grand Cherokee L Limited, RWD
Default Action
2024 Jeep Grand Cherokee L Limited, RWDSECTION Default Action
- The 5-Volt Supply circuit remains disabled while this fault is set.
- Service telltale lamp will be illuminated and on-screen message to service 4WD system will be displayed.
- T-CASE SHIFTING: Remain in position. No Range changes allowed.
- FRONT AXLE DISCONNECT (FAD) ACTUATOR: FAD Actuator will remain in the current position.
- REAR AXLE LOCKER ACTUATOR: Normal Operation.
- T-CASE FRONT DRIVE CLUTCH: Remain in position. No Range changes allowed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.