Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE L LIMITED, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULE (BCM) - DTCS P04C1-15 TO U014D-00DTC TROUBLESHOOTINGP2065-15 - FUEL LEVEL SENSOR 2 - CIRCUIT SHORT TO BATTERY OR OPEN
2024 Jeep Grand Cherokee L Limited, RWD
P2065-15 - Fuel Level Sensor 2 - Circuit Short To Battery Or Open
2024 Jeep Grand Cherokee L Limited, RWDSECTION P2065-15 - Fuel Level Sensor 2 - Circuit Short To Battery Or Open
Set Conditions:
- When the ignition is on and the Body Control Module (BCM) detects greater than 1433.0 Ohms on the Fuel Level Sensor 2 Signal circuit for greater than 10 seconds.
Diagnostic Repair:
- For Body Control Module (BCM) Fuel Level Sensor DTCs, perform the equivalent Fuel Level Sensor DTC diagnostic procedure in the Powertrain Control Module (PCM). Refer to 2.0L POWERTRAIN CONTROL MODULE (PCM), DIAGNOSTIC CODE INDEX or 3.6L POWERTRAIN CONTROL MODULE (PCM), DIAGNOSTIC CODE INDEX or 5.7L POWERTRAIN CONTROL MODULE (PCM), DIAGNOSTIC CODE INDEX .
NOTE:
- For BCM DTC P0460-11 or P2065-11 (CIRCUIT SHORT TO GROUND) - Perform the diagnostic procedure for PCM DTC P0462 or P2067 (CIRCUIT LOW).
- For BCM DTC P0460-15 or P2065-15 (CIRCUIT SHORT TO VOLTAGE OR OPEN) - Perform the diagnostic procedure for PCM DTC P0463 or P2068 (CIRCUIT HIGH).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.