Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE ALTITUDE X, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXDTC INDEX (1 OF 3)MODULE, DRIVER ALERT LIGHT (DALM)
2024 Jeep Grand Cherokee Altitude X, RWD
Module, Driver Alert Light (DALM)
2024 Jeep Grand Cherokee Altitude X, RWDSECTION Module, Driver Alert Light (DALM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B210A-00 | SYSTEM VOLTAGE LOW |
| B210B-00 | SYSTEM VOLTAGE HIGH |
| B210D-00 | BATTERY VOLTAGE LOW |
| B210E-00 | BATTERY VOLTAGE HIGH |
| B222D-00 | ECU UNABLE TO CONFIGURE/CONFIGURATION NOT LEARNED |
| B22A9-00 | ECU INTERNAL PERFORMANCE |
| B281B-02 | DRIVER ALERT LIGHT UNIT - GENERAL SIGNAL FAILURE |
| B281B-96 | DRIVER ALERT LIGHT UNIT - COMPONENT INTERNAL FAILURE |
| P1C8D-00 | POWER SUPPLY 1 CIRCUIT/OPEN |
| P1D5E-19 | POWER SUPPLY 1 CIRCUIT FAULT-OVERCURRENT |
| U0010-00 | CAN INTERIOR BUS |
| U0011-00 | CAN INTERIOR BUS OFF PERFORMANCE |
| U0140-00 | LOST COMMUNICATION WITH BODY CONTROL MODULE |
| U015C-00 | LOST COMMUNICATION WITH AUTOMATED DRIVING SYSTEM CONTROL MODULE "A" |
| U0422-00 | IMPLAUSIBLE DATA RECEIVED FROM BODY CONTROL MODULE |
| U045D-00 | INVALID DATA RECEIVED FROM AUTOMATED DRIVING SYSTEM CONTROL MODULE "A" |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.