Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test
- CHECK FOR ANY SERVICE BULLETINS OR MODULE SOFTWARE UPDATES
- Check for any applicable Service Bulletins or Flash updates related to the DTC.
Are there any applicable Service Bulletins or Flash updates?
Yes
- Perform the applicable repair.
- Perform the CENTRAL ADAS DECISION MODULE (CADM) - MID LEVEL - VERIFICATION TEST. Refer to CENTRAL ADAS DECISION MODULE (CADM) - MID LEVEL - VERIFICATION TEST .
No
- Go To 2
- Check for any applicable Service Bulletins or Flash updates related to the DTC.
- READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR THE DTC TO RETURN
- With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
- For future reference, with the scan tool, run and save a vehicle Scan Report and all related recorded data.
- With the scan tool, erase all DTCs.
- Turn the ignition off for a minimum of 10.0 seconds.
- Turn the ignition on.
- Using the When Monitored and Set Conditions above and recorded data, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read DTCs.
Did the DTC return?
Yes
- Go To 3
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION diagnostic procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
- CHECK THE FRONT LONG RANGE CAMERA WIRING AND CONNECTIONS
- Inspect the Front Long Range Camera wiring and connections at the camera and the CADM.
Were any problems found?
Yes
- Repair as necessary.NOTE:
Turn the ignition off for a minimum of 8 minutes allowing the vehicle to do a complete power down after repair(s) or connections. This will allow you to erase the DTC.
- Perform the CENTRAL ADAS DECISION MODULE (CADM) - MID LEVEL - VERIFICATION TEST. Refer to CENTRAL ADAS DECISION MODULE (CADM) - MID LEVEL - VERIFICATION TEST .
No
- Replace the Front Long Range Camera in accordance with the Service Information. Refer to CAMERAS, REMOVAL AND INSTALLATION .
- Perform the CENTRAL ADAS DECISION MODULE (CADM) - MID LEVEL - VERIFICATION TEST. Refer to CENTRAL ADAS DECISION MODULE (CADM) - MID LEVEL - VERIFICATION TEST .
- Repair as necessary.
- Inspect the Front Long Range Camera wiring and connections at the camera and the CADM.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.