Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE ALTITUDE X, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASCENTRAL ADAS DECISION MODULE (CADM) - LOW LEVEL - DTCS B1EAD-2A TO C00C1-16
2024 Jeep Grand Cherokee Altitude X, RWD
Central ADAS Decision Module (CADM) - Low Level - DTCS B1EAD-2A To C00C1-16
2024 Jeep Grand Cherokee Altitude X, RWDSECTION Central ADAS Decision Module (CADM) - Low Level - DTCS B1EAD-2A To C00C1-16
- DTC Troubleshooting
- B1EAD-2A-Lane Departure Warning Switch - Stuck
- C008E-00-Ecu Internal Performance
- C00C0-11-Front Radar Module "A" - Circuit Short To Ground
- C00C0-12-Front Radar Module "A" - Circuit Short To Battery
- C00C0-13-Front Radar Module "A" - Circuit Open
- C00C0-16-Front Radar Module "A" - Circuit Voltage Below Threshold
- C00C0-17-Front Radar Module "A" - Circuit Voltage Above Threshold
- C00C0-49-Front Radar Module "A" - Internal Electronic Failure
- C00C0-4A-Front Radar Module "A" - Incorrect Component Installed
- C00C0-4B-Front Radar Module "A" - Over Temperature
- C00C0-76-Front Radar Module "A" - Wrong Mounting Position
- C00C0-86-Front Radar Module "A" - Signal Invalid
- C00C0-87-Front Radar Module "A" - Missing Message
- C00C0-97-Front Radar Module "A" - Component Or System Operation Obstructed Or Blocked
- C00C1-11-Front Radar Module "B" - Circuit Short To Ground
- C00C1-12-Front Radar Module "B" - Circuit Short To Battery
- C00C1-13-Front Radar Module "B" - Circuit Open
- C00C1-16-Front Radar Module "B" - Circuit Voltage Below Threshold
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.