Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE ALTITUDE X, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULE (BCM) - DTCS B1642-15 TO B1707-15DTC TROUBLESHOOTINGB16DF-11-RIGHT TAILLAMP 1 CONTROL-CIRCUIT SHORT TO GROUNDSET CONDITION
2024 Jeep Grand Cherokee Altitude X, RWD
Set Condition
2024 Jeep Grand Cherokee Altitude X, RWDSECTION Set Condition
- When the Park Lamps are active and the Body Control Module (BCM) detects the amperage on the Right Park Lamp Driver circuit is greater than:
- Bulb Equipped - 3.1 amperes.
- LED Equipped - 1.3 amperes.
- After three consecutive failed retry attempts the BCM will disable the output for the remainder of the ignition cycle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.