Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSJEEP2024GRAND CHEROKEE ALTITUDE X, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOLLISION/AVOIDANCECENTRAL ADAS DECISION MODULE (CADM2) - DTCS C2129-16 TO U0402-00DTC TROUBLESHOOTINGP0602-00-CONTROL MODULE PROGRAMMING ERROR/NOT PROGRAMMEDWHEN MONITORED
2024 Jeep Grand Cherokee Altitude X, RWD
When Monitored
2024 Jeep Grand Cherokee Altitude X, RWDSECTION When Monitored
- Ignition in the run position for at least 5.0 seconds.
- Central ADAS Decision Module 2 (CADM2) input voltage between 6.0 - 16.0 volts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.